人間 COL4A3BP ELISA Kit (HUFI01272)- 高感度

商品名:	Human COL4A3BP / Collagen type IV alpha 3 binding protein ELISA Kit
製品コード:	HUFI01272
サイズ:	96T
エイリアス:	COL4A3BP, Collagen type IV alpha-3-binding protein, StAR-related lipid transfer protein 11, START domain-containing protein 11, StARD11, Ceramide transfer protein, hCERT, Goodpasture antigen-binding protein, GPBP, CERT, CERTL, FLJ20597, STARD11
検出方法:	Sandwich ELISA, Double Antibody
申し込み:	This immunoassay kit allows for the in vitro quantitative determination of Human COL4A3BP concentrations in serum plasma and other biological fluids.
感度:	0.094ng/ml
範囲:	0.156-10ng/ml
保管所:	4°C for 6 months
ノート:	For Research Use Only

回復:

Matrices listed below were spiked with certain level of Human COL4A3BP and the recovery rates were calculated by comparing the measured value to the expected amount of Human COL4A3BP in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	89-104	96
EDTA plasma(n=5)	85-103	93
UFH plasma(n=5)	85-104	90

直線性:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Human COL4A3BP and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	86-104%	85-102%	90-102%
EDTA plasma(n=5)	83-101%	92-97%	85-93%
UFH plasma(n=5)	84-99%	81-100%	80-91%

CV(%):

Intra-Assay: CV<8%
Inter-Assay: CV<10%

成分	量	保管所
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

必要なその他の材料と設備:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

Q9Y5P4

UniProt Protein Function:	COL4A3BP: a protein with a lipid-binding domain that mediates intracellular trafficking of ceramide in a non-vesicular manner. Implicated in human autoimmune diseases via its association with the Goodpasture antigen. Phosphorylation on Ser-132 decreases the affinity toward phosphatidylinositol 4-phosphate at Golgi membranes and reduces ceramide transfer activity. GPBP has been reported to have Ser/Thr protein kinase activity towards the Goodpasture (GP) antigen, but lacks a conventional serine/threonine kinase domain. Two human isoforms of the human protein are produced by alternative splicing.
UniProt Protein Details:	Protein type:Kinase, protein; Protein kinase, Ser/Thr (non-receptor); EC 2.7.11.9; Lipid-binding; Protein kinase, atypical; ATYPICAL group; COL4A3BP family Chromosomal Location of Human Ortholog: 5q13.3 Cellular Component: nucleoplasm; Golgi apparatus; endoplasmic reticulum membrane; mitochondrion; perinuclear region of cytoplasm; cytosol Molecular Function:protein binding; protein kinase activity Biological Process: heart morphogenesis; endoplasmic reticulum organization and biogenesis; cell proliferation; sphingolipid metabolic process; muscle contraction; sphingolipid biosynthetic process; in utero embryonic development; cell morphogenesis; lipid homeostasis; immune response; signal transduction; ceramide metabolic process; protein amino acid phosphorylation Disease: Mental Retardation, Autosomal Dominant 34
NCBI Summary:	This gene encodes a kinase that specifically phosphorylates the N-terminal region of the non-collagenous domain of the alpha 3 chain of type IV collagen, known as the Goodpasture antigen. Goodpasture disease is the result of an autoimmune response directed at this antigen. One isoform of this protein is also involved in ceramide intracellular transport. Three transcript variants encoding different isoforms have been found for this gene. [provided by RefSeq, Jul 2008]
UniProt Code:	Q9Y5P4
NCBI GenInfo Identifier:	20978413
NCBI Gene ID:	10087
NCBI Accession:	Q9Y5P4.1
UniProt Secondary Accession:	Q9Y5P4,Q53YV1, Q53YV2, Q96Q85, Q96Q88, Q9H2S7, Q9H2S8 A8K7S2, B3KUB7,
UniProt Related Accession:	Q9Y5P4
Molecular Weight:	83,708 Da
NCBI Full Name:	Collagen type IV alpha-3-binding protein
NCBI Synonym Full Names:	collagen, type IV, alpha 3 (Goodpasture antigen) binding protein
NCBI Official Symbol:	COL4A3BP
NCBI Official Synonym Symbols:	CERT; GPBP; CERTL; STARD11
NCBI Protein Information:	collagen type IV alpha-3-binding protein; hCERT; ceramide transporter; ceramide transfer protein; lipid-transfer protein CERTL; StAR-related lipid transfer (START) domain containing 11
UniProt Protein Name:	Collagen type IV alpha-3-binding protein
UniProt Synonym Protein Names:	Ceramide transfer protein; hCERT; Goodpasture antigen-binding protein; GPBP; START domain-containing protein 11; StARD11; StAR-related lipid transfer protein 11
Protein Family:	Collagen type IV alpha-3-binding protein
UniProt Gene Name:	COL4A3BP
UniProt Entry Name:	C43BP_HUMAN

*ノート: プロトコルは、各バッチ/ロットに固有です。正しい手順については、キットに含まれているプロトコルに従ってください。

ウェルに加える前に、SABCワーキング溶液とTMB基質を37°Cで少なくとも30分間平衡化します。サンプルと試薬を希釈するときは、完全に均一に混合する必要があります。各テストの標準曲線をプロットすることをお勧めします。

ステップ	プロトコル
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µl of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µl of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

ELISAアッセイを実施する場合、可能な限り最良の結果を達成するためにサンプルを準備することが重要です。以下に、さまざまなサンプルタイプのサンプルを準備するための手順のリストを示します。

サンプルタイプ	プロトコル
血清	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
プラズマ	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
尿および脳脊髄液	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
細胞培養上清	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
細胞溶解物	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
組織ホモジネート	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
組織溶解物	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
母乳	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.